Hi,
I ran into a strange problem.
when i enter a custom action from a merge module to the sequence I can't see on the uper right hand side the properties of the custom action as can be seen on other custom and standard actions (sequence number, condition, comments)
I ran into this problem with IS2008, while working with eralier versions it is OK (IS8,IS9)
is that a known problem, is there hotfix? i couldn't find any info in macrovision support site.
thanks,
Dana
This is a ready-only archive of the InstallSite Forum. You cannot post any new content here. / Dies ist ein Archiv des InstallSite Forums. Hier können keine neuen Beiträge veröffentlicht werden.
CA info missing in IS2008
Started by
danalifs
, Apr 23 2009 14:33
2 replies to this topic