I am installing an NT-Service and the only 3 options I see in the IDE for Error Control are:
Log the error and restart
Log the error, display a message, and continue
Log the error and continue
However, once the Service is installed, if I choose the Properties of it from the Services Snap-In, I see the following on the Recovery tab:
First Failure
Second Failure
Subsequent Failures
each has the following choices:
Take No Action
Restart the Service
Run a File
Reboot the Computer
My question is, how do I set these? Can it be done from the IDE or do I need a custom action?
Thank you,
Joe