I am using Install Shield X and I want to be able to use a Basic MSI project also in the silent mode.
After typing "Setup /s /v/qn" the installation is running just fine. The installed application is working after the installation, but: When I tried to uninstall the program again, I found out that it had no been added to the "Add/remove programs" entries.
It is added, when I do not run in silent mode.
Any ideas' what might be wrong?
This is a ready-only archive of the InstallSite Forum. You cannot post any new content here. / Dies ist ein Archiv des InstallSite Forums. Hier können keine neuen Beiträge veröffentlicht werden.
Silent Mode does not write to"Add/remove programs"
Started by
Merold
, Jul 21 2004 09:40
1 reply to this topic