Hi,
I have standard project in IS Developer. I set in Project properties - enable maintenance to NO, but still when I run the setup after I have installed my application it always starts the maintenance mode. Is there other place where I have to disable it?
Thx for suggestions.
M.
This is a ready-only archive of the InstallSite Forum. You cannot post any new content here. / Dies ist ein Archiv des InstallSite Forums. Hier können keine neuen Beiträge veröffentlicht werden.
Maintenance mode
Started by
Misec
, Aug 08 2002 12:18
2 replies to this topic