Jump to content


This is a ready-only archive of the InstallSite Forum. You cannot post any new content here. / Dies ist ein Archiv des InstallSite Forums. Hier können keine neuen Beiträge veröffentlicht werden.
Photo

How to change the properties of the setup-exe-file


3 replies to this topic

Skreboy

Skreboy
  • Members
  • 7 posts

Posted 31 December 2005 - 18:02

Hello,

I want to change the properties of the setup.exe file (rmb on the file, then properties), but I don't know where I can change it.

I always get the information that the file comes for InstallShiled etc. (see the picture), but I want to put my own properties :-(

Where can I cange the properties???

Thanks

Bye Skreboy

Attached Images

  • info.gif

Edited by Skreboy, 31 December 2005 - 18:07.

Skreboy

Stefan Krueger

Stefan Krueger

    InstallSite.org

  • Administrators
  • 13,269 posts

Posted 01 January 2006 - 17:35

Well, the file (the stub) *is* from InstallShield. As far as I know you can only set the additional information. Unless you want to patch the stub exe.

Skreboy

Skreboy
  • Members
  • 7 posts

Posted 01 January 2006 - 19:41

Thank you for the fast response. Can you give me some information about "how to patch" the file?

Thanks
Manuel
Skreboy

Stefan Krueger

Stefan Krueger

    InstallSite.org

  • Administrators
  • 13,269 posts

Posted 02 January 2006 - 18:24

You could open it "as resource" in Visual Studio.
Note: I haven't tested this, and I don't recommend this. It may cause problems, e.g. with virus scanners. And it may not comply with your EULA.