Jump to content


This is a ready-only archive of the InstallSite Forum. You cannot post any new content here. / Dies ist ein Archiv des InstallSite Forums. Hier können keine neuen Beiträge veröffentlicht werden.
Photo

How to update feature


3 replies to this topic

Thomas Eskesen

Thomas Eskesen
  • Members
  • 86 posts

Posted 22 May 2001 - 08:32

Hi

I would like to be able to change a feature (to patch a file with some new data) When I run (change) setup in Maintenance mode!

How do I detect that a feature is selected in Maintenance mode?
The &Feature>2 doen't work - it only works in Install-mode!!!

Regards,
Thomas Eskesen


Ian Blake

Ian Blake
  • Members
  • 483 posts

Posted 22 May 2001 - 09:02

Are you sure it does not work.  I would expect &Feature to be valid in any sequence after CostFinalize.

I have seen a few posts discussing delaying costing to help set up complex initial conditions.  If you have done this make sure that you are completing costing in the maintenance path as well as the first install path.


Thomas Eskesen

Thomas Eskesen
  • Members
  • 86 posts

Posted 22 May 2001 - 09:34

Sorry you are right!!!
&Feature>2 WORKS - I just made a fatal typing error...

Regards,
Thomas