Hello everyone,
During building updater I removed a file by adding a new entry ni RemoveFile table. after update the file is removed.
But If I run the repair, after update, the file is again installed.
In InstallMode column, I have specified value "3".
What should I change to make sure that file is not installed even after repair.
thank you,
ankur tyagi
This is a ready-only archive of the InstallSite Forum. You cannot post any new content here. / Dies ist ein Archiv des InstallSite Forums. Hier können keine neuen Beiträge veröffentlicht werden.
File in RemoveFile Table
Started by
antyagi
, Feb 07 2007 15:23
2 replies to this topic
Posted 11 February 2007 - 21:38
Change the condition of the component to 0 and set re-evaluate condition to yes.
Stefan Krüger
InstallSite.org twitter facebook
Posted 12 February 2007 - 14:54
I did not change the condition, i think its already evaluating to 0 when required, but setting reevaluate to yes worked.
Thank you.
Thank you.
ankur tyagi