Hello,
i have the following problem:
i install a NT Service, that works fine.
Then i give the installed service a username and a password.
When i now run a major Upgrade, the username and the password are away, the service stands on "System account"
But i dont want the user always to reenter the password every time i run an update.
What can i do ?????
Many thanks in advance.
This is a ready-only archive of the InstallSite Forum. You cannot post any new content here. / Dies ist ein Archiv des InstallSite Forums. Hier können keine neuen Beiträge veröffentlicht werden.
Updating NT Services
Started by
Burhan
, Mar 27 2006 13:54
4 replies to this topic
Stefan Krueger
-
- Administrators
- 13,269 posts
InstallSite.org
Posted 28 March 2006 - 15:07
Which project type are you using? Please post your question only in the forum that matches your project type. There's no need to cross-post it all over the forum and to send it by e-mail additionally.
Stefan Krüger
InstallSite.org twitter facebook
Burhan
-
- Full Members
- 17 posts
Posted 29 March 2006 - 07:07
Sorry,
i have thought, that i can reach more answers when i post in many groups.
I think this was a mistake.
Sorry again.
Best regards,
Burhan.
i have thought, that i can reach more answers when i post in many groups.
I think this was a mistake.
Sorry again.
Best regards,
Burhan.
Stefan Krueger
-
- Administrators
- 13,269 posts
InstallSite.org
Posted 29 March 2006 - 09:49
Property values are not persited. You could store them in registry, but for a password that's not a good idea. Please try changing the Upgrade setting so that the old version will be removed after the new version has been installed. If that doesn't help you could put the following condition on the DeleteServices action: Not UPGRADINGPRODUCTCODE
Stefan Krüger
InstallSite.org twitter facebook